Caltech Engineering Services offers Multi- Purpose Gauge or Master Paint Plate a very useful gauge for cross cut adhesion testing as per ASTM D6677, ASTM D3359 Method A and ASTM D3359 method B standard. This gauge is also useful for X Cut Knife Test, determination of wet film thickness and also used to determine sagging properties. ASTM D3359 Test Method A is primarily intended for use at job sites while Test Method B is more suitable for use in the laboratory. Also, Test Method B is not considered suitable for films thicker than 5 mils (125μm)
One Gauge with following features:
- Multi-purpose surface testing equipment: Cross-cut tester for the adhesion assessment of thin and thick single or multi coat systems in line with Test Method A and Test Method B. Applicator for the preparation of wedge-shaped layers of coating materials, sagging applicator for determining the sagging properties and wet-film thickness gauge for testing the film thickness.
- 6 different cross-cut tests with easy positioning by use of vision panel integrated in one.
- Instrument, amongst others the lattice pattern with 11 cuts according to ASTM D 3359 method B
- Made of stainless steel.
Ask for complete multi purpose gauge kit which includes multi-purpose gauge, knife, and adhesive tape, magnifier and operating manual.
|Multi-purpose gauge / Master Paint Plate|
|CCT123||Multi-purpose gauge / Master Paint Plate|
|XA001||gap heights: 0 mm to 2 mm (0“ - 0.08“), sagging: 0.25 mm to 4.0 mm (0.01“ - 0.16“), wet film thickness: 50 µm to 500 µm (2.0 mil - 19.7 mil)|
|Standards||ASTM D6677 ASTM D3359, EN ISO 2409, EN ISO 2808, EN ISO 3359|