|
Recommended accessories to be used when using the Cross Hatch Cutter. Both the viewing lens and tape are detailed in the ISO2409 standard.
|
 |
 |
Simple operation, each cross hatch cutter has 6 cutting blades spaced either 1mm or 2mm apart, one cutting pass makes 6 cuts in the coating, a second pass at 90° makes a square lattice pattern. Apply special adhesive tape over cut section and within 5 minutes remove tape. Classify the cut area according to the relevant national standard classification guide. This test conforms to BS 3900:E6, ASTM D 3359, BS/DIN EN ISO 2409
The cutting blades are ground onto 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use. Therefore giving a 1/3 rd extra life over conventional 4 sided models.
|
|
Part Numbers
|
X1002 - Adhesion Test Tape complies with ISO 2409
X1022 - Viewing Lens complies with ISO 2409 |
| |
|
|
| |
Caltech
Engineering Services
D-104, Twin Arcade, Military Road, Marol, Andheri (East),
Mumbai- 400 059 India
Tel: (+91-22) 29204050 / 29201454 Fax: (+91-22) 29250932
Email: info@caltechindia.com
|
|
|
